Rohde & Schwarz ESW Series - Items to Store

Remote Commands in the Receiver Application
R&S
®
ESW
586User Manual 1177.6298.02 ─ 08
Parameters:
<arg0> String containing the path of the directory to delete.
Note that the directory you want to remove must be empty.
15.8.2 Items to Store
The following commands select the items to be included in the configuration file.
Depending on the used command, either the items from the entire instrument
(MMEMory:SELect[:ITEM]...), or only those from the currently selected channel
(MMEM:SELect:CHANnel[:ITEM]...) are stored.
MMEMory:SELect:CHANnel[:ITEM]:ALL...........................................................................586
MMEMory:SELect[:ITEM]:ALL.........................................................................................586
MMEMory:SELect:CHANnel[:ITEM]:DEFault.....................................................................587
MMEMory:SELect[:ITEM]:DEFault................................................................................... 587
MMEMory:SELect:CHANnel[:ITEM]:HWSettings............................................................... 587
MMEMory:SELect[:ITEM]:HWSettings..............................................................................587
MMEMory:SELect:CHANnel[:ITEM]:LINes:ALL................................................................. 587
MMEMory:SELect[:ITEM]:LINes:ALL................................................................................587
MMEMory:SELect:CHANnel[:ITEM]:NONE....................................................................... 588
MMEMory:SELect[:ITEM]:NONE..................................................................................... 588
MMEMory:SELect:CHANnel[:ITEM]:SGRam.....................................................................588
MMEMory:SELect[:ITEM]:SGRam................................................................................... 588
MMEMory:SELect:CHANnel[:ITEM]:TRACe[:ACTive].........................................................588
MMEMory:SELect[:ITEM]:TRACe<1...3>[:ACTive].............................................................588
MMEMory:SELect:CHANnel[:ITEM]:TRANsducer:ALL....................................................... 589
MMEMory:SELect[:ITEM]:TRANsducer:ALL......................................................................589
MMEMory:SELect:CHANnel[:ITEM]:ALL
MMEMory:SELect[:ITEM]:ALL
This command includes all items when storing or loading a configuration file.
The items are:
●
Hardware configuration: MMEMory:SELect[:ITEM]:HWSettings on page 587
●
Limit lines: MMEMory:SELect[:ITEM]:LINes:ALL on page 587
●
Spectrogram data: MMEMory:SELect[:ITEM]:SGRam on page 588
●
Trace data: MMEMory:SELect[:ITEM]:TRACe<1...3>[:ACTive]
on page 588
●
Transducers: MMEMory:SELect[:ITEM]:TRANsducer:ALL on page 589
Example:
MMEM:SEL:ALL
Manual operation: See "Items:" on page 266
Data Management