Rohde & Schwarz ESW Series - 15 Remote Commands in the Receiver Appli- Cation; 15 Remote Commands in the Receiver Application; Conventions Used in SCPI Command Descriptions

Remote Commands in the Receiver Application
R&S
®
ESW
429User Manual 1177.6298.02 ─ 08
15 Remote Commands in the Receiver Appli-
cation
● Conventions Used in SCPI Command Descriptions............................................. 429
● Common Suffixes..................................................................................................430
● Common Commands............................................................................................ 430
● Application Selection.............................................................................................435
● Measurements and Result Displays......................................................................439
● Configuration.........................................................................................................484
● Analysis.................................................................................................................517
● Data Management.................................................................................................579
● General Instrument Setup.....................................................................................620
● Using the Status Register..................................................................................... 675
● Service Request....................................................................................................679
● Reference: GPIB Commands of Emulated HP Models.........................................687
● Reference: Command Set of Emulated PSA Models............................................715
● Reference: Command Set of Emulated PXA Models............................................719
15.1 Conventions Used in SCPI Command Descriptions
Note the following conventions used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as Setting parameters.
Parameters required only to refine a query are indicated as Query parameters.
Parameters that are only returned as the result of a query are indicated as Return
values.
●
Conformity
Commands that are taken from the SCPI standard are indicated as SCPI con-
firmed. All commands used by the R&S ESW follow the SCPI syntax rules.
●
Asynchronous commands
A command which does not automatically finish executing before the next com-
mand starts executing (overlapping command) is indicated as an Asynchronous
command.
●
Reset values (*RST)
Default parameter values that are used directly after resetting the instrument (*RST
command) are indicated as *RST values, if available.
●
Default unit
Conventions Used in SCPI Command Descriptions