Common Analysis and Display Functions
R&S
®
ESW
232User Manual 1177.6298.02 ─ 08
Remote command:
CALCulate<n>:MARKer<m>:X on page 540
CALCulate<n>:DELTamarker<m>:X on page 539
Frame (Spectrogram only)
Spectrogram frame the marker is assigned to.
Remote command:
CALCulate<n>:MARKer<m>:SPECtrogram:FRAMe on page 552
CALCulate<n>:DELTamarker<m>:SPECtrogram:FRAMe on page 556
Marker Type
Toggles the marker type.
The type for marker 1 is always "Normal", the type for delta marker 1 is always "Delta".
These types cannot be changed.
Note: If normal marker 1 is the active marker, switching the "Mkr Type" activates an
additional delta marker 1. For any other marker, switching the marker type does not
activate an additional marker, it only switches the type of the selected marker.
"Normal"
A normal marker indicates the absolute value at the defined position
in the diagram.
"Delta"
A delta marker defines the value of the marker relative to the speci-
fied reference marker (marker 1 by default).
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 540
CALCulate<n>:DELTamarker<m>[:STATe] on page 538
Reference Marker
Defines a marker as the reference marker which is used to determine relative analysis
results (delta marker values).
Remote command:
CALCulate<n>:DELTamarker<m>:MREFerence on page 538
Assigning the Marker to a Trace
The "Trace" setting assigns the selected marker to an active trace. The trace deter-
mines which value the marker shows at the marker position. If the marker was previ-
ously assigned to a different trace, the marker remains on the previous frequency or
time, but indicates the value of the new trace.
If a trace is turned off, the assigned markers and marker functions are also deactiva-
ted.
Remote command:
CALCulate<n>:MARKer<m>:TRACe on page 540
Select Marker
The "Select Marker" function opens a dialog box to select and activate or deactivate
one or more markers quickly.
Marker Usage
To Next Page
Loading...
