Rohde & Schwarz ESW Series - Configuring Lisns; Configuring Additional Outputs

Common Measurement Settings
R&S
®
ESW
167User Manual 1177.6298.02 ─ 08
A similar functionality is available in the "Phones" tab of the "Output Config" dialog box.
The volume control slider has the same effect as the volume control knob. For the
slider, the volume is a percentage from 0 % to 100 % with 100 % being the loudest.
In addition to simply changing the volume, you can also define a maximum volume
level. The maximum volume level limits the audio output to a certain level. The volume
control knob and slider will not go further than this level.
Remote command:
Volume: SYSTem:SPEaker:VOLume on page 500
Maximum volume: SYSTem:SPEaker:MAXVolume on page 500
Mute: SYSTem:SPEaker:MUTE on page 500
10.6.5 Configuring LISNs
For more information see Chapter 9.3.6, "Configuring Line Impedance Stabilization
Networks (LISN)", on page 135.
10.6.6 Configuring Additional Outputs
Access: "Overview" > "Output" > "Additional Outputs"
The R&S ESW provides additional outputs that you can use for various tasks.
The remote commands required to configure the outputs are described in Chap-
ter 15.6.2.2, "Additional Output", on page 501.
Providing output for LISN control is described in Chapter 9.3.1.3, "Line Impedance Sta-
bilization Network (LISN) Control", on page 105.
Probe Power Supply................................................................................................... 167
Trigger 2/3...................................................................................................................168
└ Output Type.................................................................................................. 168
└ Level................................................................................................... 168
└ Pulse Length.......................................................................................169
└ Send Trigger....................................................................................... 169
Probe Power Supply
Selects the probe connector that is supplied with power.
The probe power supply is a global setting - when you change it in one measurement
channel, it is also changed in the others.
"Probe 1"
Supplies the 3-pin probe connector with power.
"Probe 2"
Supplies the 5-pin probe connector with power.
"Off"
Turns off the power supply for the probe connectors.
Data Input and Output