Rohde & Schwarz ESW Series - How to Align the Touchscreen; Display Settings

General Instrument Setup
R&S
®
ESW
305User Manual 1177.6298.02 ─ 08
To perform a self-alignment
1. Press the [SETUP] key.
2. Select the "Alignment" softkey.
3. Select the "Start Self Alignment" button.
4. To abort the self-alignment process, select the "Abort Self Alignment" button.
Once the system correction values have been calculated successfully, a message
is displayed.
To display the alignment results again later
●
Press the [SETUP] key.
●
Press the "Alignment" softkey.
13.1.5 How to Align the Touchscreen
To align the touchscreen
1. Press the [Setup] key.
2. Select the "Alignment" softkey.
3. Select "Touch Screen Alignment".
A blinking cross appears in the lower left corner of the screen.
4. Touch and hold the blinking cross until it stops blinking.
Repeat this action for the crosses in the other corners.
13.2 Display Settings
13.2.1 Display Settings
Access: [Setup] > "Display"
Some general display settings are available regardless of the current application or
operating mode. For information on optimizing your display for measurement results,
see Chapter 11.1, "Result Display Configuration", on page 190.
● General Display Settings.......................................................................................306
● Displayed Items.....................................................................................................307
● Display Theme and Colors....................................................................................310
● External Monitor Settings......................................................................................314
Display Settings