Rohde & Schwarz ESW Series - Output Configuration

Remote Commands in the Receiver Application
R&S
®
ESW
495User Manual 1177.6298.02 ─ 08
If the user port is programmed to input instead of output (see INPut<ip>:UPORt:
STATe on page 494), the output value is temporarily stored.
Suffix:
<up>
.
irrelevant
Parameters:
<Value> bit values in hexadecimal format
TTL type voltage levels (max. 5V)
Range: #B00000000 to #B00111111
Example:
OUTP:UPOR #B00100100
Sets pins 5 and 7 to 5 V.
Manual operation: See "User port configuration" on page 145
OUTPut<up>:UPORt:STATe <State>
This command toggles the control lines of the user ports for the AUX PORT connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S ESW.
Suffix:
<up>
.
irrelevant
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
User port is switched to INPut
ON | 1
User port is switched to OUTPut
Example:
OUTP:UPOR:STAT ON
Manual operation: See "User port configuration" on page 145
15.6.2 Output Configuration
● IF / Video / Demodulation......................................................................................495
● Additional Output...................................................................................................501
15.6.2.1 IF / Video / Demodulation
OUTPut<ou>:IF:AUDio................................................................................................... 496
OUTPut<ou>:IF:COUPling.............................................................................................. 496
OUTPut<ou>:IF:IFFRequency.........................................................................................496
OUTPut<ou>:IF:LPASs:FREQuency:MANual....................................................................497
OUTPut<ou>:IF:LPASs[:STATe].......................................................................................497
OUTPut<ou>:IF:SCALe[:VALue]...................................................................................... 498
OUTPut<ou>:IF[:SOURce]..............................................................................................498
OUTPut<ou>:LINK.........................................................................................................499
[SENSe:]DEMod:SQUelch:LEVel.....................................................................................499
Configuration