Operating the Instrument
R&S
®
ESW
72User Manual 1177.6298.02 ─ 08
Key name
(upper inscription)
Series of (special) characters and number provided
9 D E F 9 É
4 G H I 4
5 J K L 5
6 M N O 6 Ň Ö
1 P Q R S 1
2 T U V 2 Ü
3 W X Y Z 3
0 <blank> 0 – @ + / \ < > = % &
. . * : _ , ; " ' ? ( ) #
– <toggles between capital and small letters>
6.5 Displaying Results
The R&S ESW provides several instrument applications for different analysis tasks and
different types of signals, for example the Receiver application, the Spectrum applica-
tion or the I/Q Analyzer. For each application, a new measurement channel is created
and displayed in a separate tab on the screen.
The results of a measurement channel can be evaluated in many different ways, both
graphically and numerically. For each evaluation method the results are displayed in a
separate window in the tab.
The R&S ESW allows you to configure the display to suit your specific requirements
and optimize analysis.
6.5.1 Activating and Deactivating Channels
When you activate an application, a new measurement channel is created which deter-
mines the measurement settings for that application. The same application can be acti-
vated with different measurement settings by creating several channels for the same
application. Whenever you switch channels, the corresponding measurement settings
are restored. Each channel is displayed in a separate tab on the screen.
An additional tab ("MultiView") provides an overview of all currently active channels at
once.
Only one measurement can be performed at any time, namely the one in the currently
active channel. However, in order to perform the configured measurements consecu-
tively, a Sequencer function is provided.
Displaying Results
To Next Page
Loading...
