Remote Commands in the Receiver Application
R&S
®
ESW
445User Manual 1177.6298.02 ─ 08
A detailed programming example is provided in Chapter 15.5.13, "Programming Exam-
ple: Performing a Sequence of Measurements", on page 482.
Parameters:
<State> ON | OFF | 0 | 1
ON | 1
The Sequencer is activated and a sequential measurement is
started immediately.
OFF | 0
The Sequencer is deactivated. Any running sequential measure-
ments are stopped. Further Sequencer commands
(INIT:SEQ...) are not available.
*RST: 0
Example:
SYST:SEQ ON
Activates the Sequencer.
INIT:SEQ:MODE SING
Sets single Sequencer mode so each active measurement will
be performed once.
INIT:SEQ:IMM
Starts the sequential measurements.
SYST:SEQ OFF
Manual operation: See "Sequencer State" on page 93
15.5.3 Result Retrieval
● Trace Data and Result Query............................................................................... 445
15.5.3.1 Trace Data and Result Query
This section contains information on the TRACe:DATA command and a detailed
description of the characteristics of that command. Basically, the command queries the
results of the current measurement. The command supports various SCPI parameters
in combination with the query. Each SCPI parameter returns a different aspect of the
measurement.
The format of the return values is either in ASCII or binary characters and depends on
the format you have set with FORMat[:DATA] on page 580.
Querying trace data
The SCPI parameters TRACE1 | ... | TRACE6 return the trace data for the correspond-
ing trace.
Example:
TRAC? TRACE1
Measurements and Result Displays
To Next Page
Loading...
