Rohde & Schwarz ESW Series - How to Configure Traces

Common Analysis and Display Functions
R&S
®
ESW
219User Manual 1177.6298.02 ─ 08
Hot/Cold/Radar/Grayscale
Sets the color scheme for the spectrogram.
Remote command:
DISPlay[:WINDow<n>]:SPECtrogram:COLor[:STYLe] on page 536
Auto
Defines the color range automatically according to the existing measured values for
optimized display.
Set to Default
Sets the color mapping to the default settings.
Remote command:
DISPlay[:WINDow<n>]:SPECtrogram:COLor:DEFault on page 535
Close
Saves the changes and closes the dialog box.
11.3.7 How to Configure Traces
● How to Export Trace Data and Numerical Results................................................219
● How to Display and Configure a Spectrogram......................................................220
11.3.7.1 How to Export Trace Data and Numerical Results
The measured trace data and numerical measurement results in tables can be expor-
ted to an ASCII file. For each measurement point the measured trace position and
value are output.
The file is stored with a .DAT extension. For details on the storage format see Chap-
ter 11.3.8.1, "Reference: ASCII File Export Format", on page 224.
To export trace data and table results
1. Select [TRACE] > "Trace Config" > "Trace / Data Export" tab.
2. Select "Export all Traces and all Table Results" to export all available measurement
result data for the current application, or select a specific "Trace to Export".
3. Optionally, select the "Include Instrument & Measurement Settings" option to insert
additional information in the export file header.
4. If necessary, change the decimal separator to be used for the ASCII export file.
5. Select the "Export Trace to ASCII File" button.
6. In the file selection dialog box, select the storage location and file name for the
export file.
7. Select "Save" to close the dialog box and export the data to the file.
Trace Configuration