Rohde & Schwarz ESW Series - The Notes Display

Common Measurement Settings
R&S
®
ESW
145User Manual 1177.6298.02 ─ 08
The "User Port" panel is designed to configure the optional user port (AUX port) on the
rear of the R&S ESW. Using the user port, you can transmit bit patterns in two direc-
tions, depending on the actual selected signal direction.
When you add the user port panel to the user interface, you can configure the user
ports as required.
User port configuration................................................................................................145
User port configuration
You can configure the user port as an input or an output by selecting the signal "Direc-
tion".
●
When you configure the user port as an output, you can select the required bit pat-
terns by changing the state of the indivdiual ports ("Port <x>").
An active port shows a green LED.
●
When you configure the user port as an input, you can read out the user port con-
figuration. The value is displayed in the panel. Individual port selection becomes
unavailable.
For more information about the pin assignment of the user port, see Chapter 5.2.8,
"AUX Port", on page 55.
For more information about the pin to bit assignment, refer to the description of the
remote command .
Remote command:
Output state: OUTPut<up>:UPORt:STATe on page 495
Set bit pattern: OUTPut<up>:UPORt[:VALue] on page 494
Input state: INPut<ip>:UPORt:STATe on page 494
Query bit pattern: INPut<ip>:UPORt[:VALue] on page 494
10.4 The Notes Display
Access: > "Notes"
The "Notes" display is designed to add comments or explanations to the current mea-
surement.
The Notes Display