Rohde & Schwarz ESW Series - How to Zoom into the Diagram in Receiver Mode; Zoom Functions

Common Analysis and Display Functions
R&S
®
ESW
196User Manual 1177.6298.02 ─ 08
11.2.1 Zoom Functions
Access:
Single Zoom................................................................................................................196
Restore Original Display............................................................................................. 196
Deactivating Zoom (Selection Mode)........................................................................196
Single Zoom
A single zoom replaces the current diagram by a new diagram which displays an
enlarged extract of the trace. This function can be used repetitively until the required
details are visible.
Remote command:
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM[:STATe] on page 527
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM:AREA on page 526
Restore Original Display
Restores the original display, that is, the originally calculated displays for the entire
capture buffer, and closes all zoom windows.
Remote command:
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM[:STATe] on page 527
Deactivating Zoom (Selection Mode)
Deactivates any zoom mode.
Tapping the screen no longer invokes a zoom, but selects an object.
Remote command:
DISPlay[:WINDow<n>][:SUBWindow<w>]:ZOOM[:STATe] on page 527
11.2.2 How to Zoom into the Diagram in Receiver Mode
Basically, zooming into a diagram in Receiver mode works the same as in other appli-
cations. However, the zoom function in Receiver mode is not merely a visual tool, but
actually changes settings. Also, the multiple zoom is not available.
The remote commands required to zoom into a display are described in Chap-
ter 15.7.2, "Zoomed Displays", on page 526.
To zoom into the diagram at one position
1.
Click on the "Single Zoom" icon in the toolbar.
Zoomed Displays