Remote Commands in the Receiver Application
R&S
®
ESW
528User Manual 1177.6298.02 ─ 08
15.7.3 Trace Configuration
15.7.3.1 Trace Control
For a full list of commands to control traces, see Chapter 15.5.9, "Final Measurement
(and Trace) Configuration", on page 472.
15.7.3.2 Trace Export
Commands to export traces described elsewhere.
●
FORMat:DEXPort:DSEParator on page 581
FORMat:DEXPort:HEADer..............................................................................................528
FORMat:DEXPort:TRACes............................................................................................. 528
FORMat:DEXPort:HEADer <State>
If enabled, additional instrument and measurement settings are included in the header
of the export file for result data. If disabled, only the pure result data from the selected
traces and tables is exported.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Manual operation: See "Include Instrument & Measurement Settings" on page 212
FORMat:DEXPort:TRACes <Selection>
This command selects the data to be included in a data export file (see MMEMory:
STORe<n>:TRACe on page 617).
For details on exporting data, see Chapter 11.3.3, "Trace Export", on page 211.
Parameters:
<Selection> SINGle | ALL
SINGle
Only a single trace is selected for export, namely the one speci-
fied by the MMEMory:STORe<n>:TRACe command.
ALL
Selects all active traces and result tables (e.g. Result Summary,
marker peak list etc.) in the current application for export to an
ASCII file.
The <trace> parameter for the MMEMory:STORe<n>:TRACe
command is ignored.
*RST: SINGle
Manual operation: See "Export all Traces and all Table Results" on page 212
Analysis
To Next Page
Loading...
