Rohde & Schwarz ESW Series - Configuring Outputs (if; Video; Demodulation)

Common Measurement Settings
R&S
®
ESW
163User Manual 1177.6298.02 ─ 08
For more information on coupling frequencies and reverse sweeps, see "Coupling the
Frequencies" on page 156. For more information on error messages and the channel
bar, see "Displayed Information and Errors" on page 158.
Remote command:
SOURce<si>:EXTernal<gen>:FREQuency[:FACTor]:DENominator
on page 488
SOURce<si>:EXTernal<gen>:FREQuency[:FACTor]:NUMerator on page 489
SOURce<si>:EXTernal<gen>:FREQuency:OFFSet on page 490
Result Frequency Start
For reference only: The start frequency for the generator, calculated from the config-
ured generator frequency and the start value defined for the R&S ESW.
Result Frequency Stop
For reference only: The stop frequency for the generator, calculated from the config-
ured generator frequency and the stop value defined for the R&S ESW.
Bargraph Frequency
For reference only: The current receiver frequency that the R&S ESW is tuned to and
that the bargraph evaluates (zero span frequency).
10.6.4 Configuring Outputs (IF / Video / Demodulation)
Access: "Overview" > "Output" > "Output Config"
The R&S ESW provides several outputs. The R&S ESW allows you to configure the
output as required.
For details on the connectors refer to the R&S ESW Getting Started manual, chapter
"Instrument Tour".
The remote commands required to configure the outputs are described in Chap-
ter 15.6.2.1, "IF / Video / Demodulation", on page 495.
Further information
For more information about LISN control refer to Chapter 9.3.1.3, "Line Impedance
Stabilization Network (LISN) Control", on page 105.
Data Input and Output