General Instrument Setup
R&S
®
ESW
331User Manual 1177.6298.02 ─ 08
For details on the required file format see Chapter 13.3.3, "Reference: Transducer Fac-
tor File Format", on page 327.
1. In the "Edit Transducer" dialog box, select the transducer factor.
2. Select the "New" or "Edit" button.
3. Select "Import" to load a transducer factor from a file.
You are asked whether you would like to save the current configuration on the
R&S ESW first.
4. Select the file name of the transducer factor.
5. Select the decimal separator that was used in the file.
6. Select "Select".
The transducer factor is loaded from the specified file and displayed in the "Edit
Transducer" dialog box.
7. Activate the transducer factor as described in "How to activate and deactivate a
transducer" on page 328.
13.4 Reference Frequency Settings
Access: [Setup] > "Reference"
Reference Frequency Input.........................................................................................332
└ Behavior in case of missing external reference............................................ 332
└ Tuning Range............................................................................................... 333
└ Frequency.....................................................................................................333
└ Loop Bandwidth............................................................................................ 333
Reference Frequency Output......................................................................................333
Resetting the Default Values.......................................................................................334
Reference Frequency Settings
To Next Page
Loading...
