General Instrument Setup
R&S
®
ESW
328User Manual 1177.6298.02 ─ 08
The transducer settings are defined in the "Transducer" dialog box which is displayed
when you press the [Setup] key and then select "Transducer".
Stored transducer settings
When storing and recalling transducer settings, consider the information provided in
"Saving and recalling transducer and limit line settings" on page 261.
The following tasks are described:
●
"How to find compatible transducer lines" on page 328
●
"How to activate and deactivate a transducer" on page 328
●
"How to edit existing transducer lines" on page 328
●
"How to copy an existing transducer line" on page 329
●
"How to delete an existing transducer line" on page 329
●
"How to configure a new transducer line" on page 329
●
"How to move the transducer line vertically or horizontally" on page 330
How to find compatible transducer lines
► In the "Transducer" dialog box, select the "View Filter" option: "Show Compatible".
All transducer lines stored on the instrument that are compatible to the current
measurement settings are displayed in the overview.
How to activate and deactivate a transducer
1. To activate a transducer select a transducer line in the overview and select the
"Active" setting for it.
The trace is automatically recalculated for the next sweep after a transducer line is
activated.
2. To deactivate a transducer line, deactivate the "Active" setting for it.
After the next sweep, the originally measured values are displayed.
How to edit existing transducer lines
Existing transducer line configurations can be edited.
1. In the "Transducer" dialog box, select the transducer line.
2. Select the "Edit" button.
3. Edit the line configuration as described in "How to configure a new transducer line"
on page 329.
4. Save the new configuration by selecting the "Save" button.
The trace is automatically recalculated for the next sweep if the transducer line is
active.
Transducers
To Next Page
Loading...
