Rohde & Schwarz ESW Series - Compatibility Settings; Language

Network and Remote Operation
R&S
®
ESW
403User Manual 1177.6298.02 ─ 08
Only the most recent error is displayed in remote mode. However, in local mode, all
errors that occurred during remote operation are listed in a separate tab of the "Net-
work + Remote" dialog box (see Chapter 14.4.5, "Remote Errors", on page 407).
Remote command:
SYSTem:ERRor:DISPlay on page 662
SYSTem:ERRor:CLEar:REMote on page 662
14.4.3 Compatibility Settings
The R&S ESW can emulate the GPIB interface of other signal and spectrum analyzers,
e.g. in order to use existing control applications.
Compatibility with former R&S signal and spectrum analyzers
As a rule, the R&S ESW supports most commands from previous R&S signal and
spectrum analyzers such as the FSQ, FSP, FSU, or FSV. However, the default values,
in particular the number of sweep points or particular bandwidths, may vary. Therefore,
the R&S ESW can emulate these other devices, including their default values, in order
to repeat previous measurements or support existing control applications as in legacy
systems.
The required settings are configured in the "Compatibility" tab of the "Network
+Remote" dialog box.
Language.................................................................................................................... 403
IF Gain........................................................................................................................ 404
Sweep Repeat.............................................................................................................404
Coupling......................................................................................................................404
Wideband....................................................................................................................405
Revision String............................................................................................................405
Resetting the Factory Revision................................................................................... 405
Language
Defines the system language used to control the instrument.
Network and Remote Control Settings