Rohde & Schwarz ESW Series - Application Selection

Remote Commands in the Receiver Application
R&S
®
ESW
435User Manual 1177.6298.02 ─ 08
Usage: Event
15.4 Application Selection
CALCulate:STATistics:CAPD[:STATe]...............................................................................435
DISPlay:ATAB................................................................................................................435
INSTrument:CREate:DUPLicate...................................................................................... 436
INSTrument:CREate[:NEW]............................................................................................ 436
INSTrument:CREate:REPLace........................................................................................ 436
INSTrument:DELete....................................................................................................... 437
INSTrument:LIST?......................................................................................................... 437
INSTrument:REName.....................................................................................................438
INSTrument[:SELect]......................................................................................................438
CALCulate:STATistics:CAPD[:STATe] <State>
This command creates a new measurement channel for the CISPR APD measure-
ment.
Note that this is only possible from within a selected spectrum channel.
Parameters:
<State> ON | OFF
OFF returns to the spectrum application.
*RST: OFF
Example:
INST:CRE SAN, 'Spectrum'
INST 'Spectrum'
Creates and selects the Spectrum channel.
CALC:STAT:CAPD ON
Opens a CISPR APD channel.
DISPlay:ATAB <State>
This command switches between the MultiView tab and the most recently displayed
channel. If only one channel is active, this command has no effect.
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Application Selection