Rohde & Schwarz ESW Series - Page 438

Remote Commands in the Receiver Application
R&S
®
ESW
438User Manual 1177.6298.02 ─ 08
Table 15-2: Available channel types and default channel names
Application <ChannelType> Parameter Default Channel Name*)
Receiver RECeiver Receiver
CISPR APD n/a
Use CALCulate:
STATistics:CAPD[:STATe]
Use
CALCulate:STATistics:
CAPD[:STATe]
CISPR APD
Spectrum SANalyzer Spectrum
I/Q Analyzer IQ IQ Analyzer
Real-Time Spectrum RTIM Real-Time Spectrum
Analog Demodulation ADEMod Analog Demod
Note: the default channel name is also listed in the table. If the specified name for a new channel already
exists, the default name, extended by a sequential number, is used for the new channel.
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a channel.
Setting parameters:
<ChannelName1> String containing the name of the channel you want to rename.
<ChannelName2> String containing the new channel name.
Note that you cannot assign an existing channel name to a new
channel; this will cause an error.
Channel names can have a maximum of 31 characters, and
must be compatible with the Windows conventions for file
names. In particular, they must not contain special characters
such as ":", "*", "?".
Example:
INST:REN 'Receiver','REC'
Renames the channel with the name 'Receiver' to 'REC'.
Usage: Setting only
INSTrument[:SELect] <ChannelType> | <ChannelName>
This command activates a new channel with the defined channel type, or selects an
existing channel with the specified name.
Also see
●
INSTrument:CREate[:NEW] on page 436
Parameters:
<ChannelType> Channel type of the new channel.
For a list of available channel types see INSTrument:LIST?
on page 437.
Application Selection