Rohde & Schwarz ESW Series - Bargraph Configuration

Remote Commands in the Receiver Application
R&S
®
ESW
450User Manual 1177.6298.02 ─ 08
TRACe<n>:POINts <LIMit>, <Points>
This command defines the maximum number of measurement points that are transfer-
red in one block after using TRAC? SCAN.
The total number of bytes which is transferred depends on the number of active traces.
Suffix:
<n>
.
irrelevant
Parameters:
<LIMit>
<Points> Range: 1 to 10000
*RST: 1000
Example: //Transfer a maximum of 8000 measurement values per trace
with a single query
TRAC:POIN LIM, 8000
15.5.4
Bargraph Configuration
DISPlay:BARGraph:LEVel:LOWer?..................................................................................450
DISPlay:BARGraph:LEVel:UPPer?.................................................................................. 450
DISPlay:BARGraph:PHOLd:RESet.................................................................................. 451
DISPlay:BARGraph:PHOLd[:STATe].................................................................................451
DISPlay:BARGraph:TCOupling[:STATe]............................................................................451
[SENSe:]DETector<t>:RECeiver[:FUNCtion]..................................................................... 451
[SENSe:]SWEep:TIME................................................................................................... 452
DISPlay:BARGraph:LEVel:LOWer?
This command queries the level range of the bargraph.
Return values:
<Level> Lowest level displayed on the bargraph scale.
Default unit: depends on the selected unit
Example: //Query bargraph minimum level
DISP:BARG:LEV:LOW?
would return, e.g.
10
Usage: Query only
DISPlay:BARGraph:LEVel:UPPer?
This command queries the level range of the bargraph.
Return values:
<Level> Highest level displayed on the bargraph scale.
Default unit: depends on the selected unit
Measurements and Result Displays