Rohde & Schwarz ESW Series - Page 449

Remote Commands in the Receiver Application
R&S
®
ESW
449User Manual 1177.6298.02 ─ 08
SINGle
See "Querying bargraph results" on page 446.
STATus
See "Querying scan characteristics" on page 446.
Return values:
<Result>
Example: //Query level for each trace point of trace 1.
TRAC? TRACE1
Usage: Query only
TRACe<n>:FEED:CONTrol
<Occasion>
This command turns block data transmission during a scan on and off.
The availability of data is reported in the STATus:OPERation register.
The block size depends on scan time and the upper limit defined by TRACe<n>:
POINts on page 450.
Suffix:
<n>
.
irrelevant
Parameters:
<Occasion> ALWays
Block data transmission is on.
NEVer
Block data transmission is off.
*RST: NEVer
Example: //Select block data transmission
TRAC:FEED:CONT ALW
TRACe<n>:IF[:DATA] <ResultType>
This command queries current trace data and measurement results for IF analysis.
The data format depends on FORMat[:DATA].
Suffix:
<n>
.
1..n
irrelevant
Parameters:
<ResultType> TRACE1 | ... | TRACE3
Returns the level values displayed on the corresponding trace.
Example: //Query the level for each trace point of trace 1
TRAC:IF? TRACE1
Measurements and Result Displays