Rohde & Schwarz ESW Series - Amplitude Configuration

Remote Commands in the Receiver Application
R&S
®
ESW
506User Manual 1177.6298.02 ─ 08
[SENSe:]FREQuency:CENTer:STEP <StepSize>
This command defines the center frequency step size.
Parameters:
<StepSize> <numeric value>
Numeric value in Hz.
Example: //Define frequency step size
FREQ:CENT:STEP 4KHZ
Manual operation: See "Frequency Stepsize" on page 180
[SENSe:]FREQuency:SCOupled <State>
This command couples or decouples the bargraph settings to the scan settings.
Parameters:
<State> LSC
Couples the bargraph settings to the settings of the last scan
that has been performed.
OFF
Decouples the bargraph settings from the scan settings.
SCAN
Couples the bargraph settings to the current scan settings or the
settings of the current scan range.
*RST: OFF
Example: //Couple bargraph settings to settings of last scan
FREQ:SCO LSC
Manual operation: See "Couple Bargraph Settings" on page 180
[SENSe:]FREQuency:SPAN <Span>
This command defines the frequency span.
Manual operation:
See "IF Analysis" on page 181
15.6.4 Amplitude Configuration
CALCulate<n>:UNIT:POWer........................................................................................... 507
INPut<ip>:ATTenuation[:VALue].......................................................................................507
INPut<ip>:ATTenuation:AMODe.......................................................................................507
INPut<ip>:ATTenuation:AUTO......................................................................................... 508
INPut<ip>:ATTenuation:PROTection[:STATe].....................................................................508
INPut<ip>:GAIN:AUTO................................................................................................... 508
INPut<ip>:GAIN:LNA:AUTO............................................................................................509
INPut<ip>:GAIN:LNA:STATe............................................................................................509
INPut<ip>:GAIN:STATe...................................................................................................509
Configuration