Rohde & Schwarz ESW Series - Measurement Control; Measurements and Result Displays

Remote Commands in the Receiver Application
R&S
®
ESW
439User Manual 1177.6298.02 ─ 08
<ChannelName> String containing the name of the channel.
Example:
INST IQ
Activates a channel for the I/Q Analyzer application (evaluation
mode).
INST 'MyIQSpectrum'
Selects the channel named 'MyIQSpectrum' (for example before
executing further commands for that channel).
Manual operation: See "Receiver" on page 87
See "CISPR APD" on page 88
See "Spectrum" on page 88
See "I/Q Analyzer" on page 88
See "Analog Demodulation" on page 88
See "Real-Time Spectrum" on page 88
See "New Channel" on page 90
15.5
Measurements and Result Displays
● Measurement Control............................................................................................439
● Measurement Sequences..................................................................................... 443
● Result Retrieval.....................................................................................................445
● Bargraph Configuration.........................................................................................450
● Scan Configuration................................................................................................453
● Scan Table Configuration......................................................................................454
● Peak Search..........................................................................................................462
● Peak List............................................................................................................... 467
● Final Measurement (and Trace) Configuration..................................................... 472
● Final Results......................................................................................................... 475
● LISN Configuration................................................................................................479
● CISPR APD Measurement Configuration............................................................. 482
● Programming Example: Performing a Sequence of Measurements.....................482
15.5.1 Measurement Control
ABORt.......................................................................................................................... 439
HOLD........................................................................................................................... 440
INITiate<mt>:CONMeas..................................................................................................440
INITiate<n>:CONTinuous................................................................................................441
INITiate<mt>:EMITest..................................................................................................... 442
INITiate<mt>:FMEasurement...........................................................................................442
INITiate<mt>[:IMMediate]................................................................................................442
ABORt
This command aborts the measurement in the current measurement channel and
resets the trigger system.
Measurements and Result Displays