Rohde & Schwarz ESW Series - System:identify[:String]; GPIB Address; Identification String; Remote Display Update

Network and Remote Operation
R&S
®
ESW
401User Manual 1177.6298.02 ─ 08
GPIB Address............................................................................................................. 401
Identification String......................................................................................................401
Reset to Factory String............................................................................................... 401
Remote Display Update.............................................................................................. 401
GPIB Terminator..........................................................................................................402
*IDN Format................................................................................................................ 402
I/O Logging..................................................................................................................402
Display Remote Errors................................................................................................402
GPIB Address
Defines the GPIB address. Values from 0 to 30 are allowed. The default address is 20.
Remote command:
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess on page 660
Identification String
Defines the identification string for the R&S ESW which is provided as a response to
the *IDN? query. Maximum 36 characters are allowed.
Remote command:
SYSTem:IDENtify[:STRing] on page 663
Reset to Factory String
Restores the default identification string. Each R&S ESW has a unique ID according to
the following syntax:
Rohde&Schwarz,ESW,<Unique number>
Remote command:
SYSTem:IDENtify:FACTory on page 663
Remote Display Update
Defines whether the display of the R&S ESW is updated when changing from manual
operation to remote control.
Turning off the display update function improves performance during remote control.
Note: Usually, this function remains available on the display during remote operation.
However, it can be disabled remotely. In this case, the display is not updated during
remote operation, and cannot be turned on again locally until local operation is
resumed.
Network and Remote Control Settings