Rohde & Schwarz ESW Series - Page 663

Remote Commands in the Receiver Application
R&S
®
ESW
663User Manual 1177.6298.02 ─ 08
Example:
SYST:ERR:DISP ON
Manual operation: See "Display Remote Errors" on page 402
SYSTem:HPCoupling <CouplingType>
Controls the default coupling ratios in the HP emulation mode for:
●
span and resolution bandwidth (Span/RBW) and
●
resolution bandwidth and video bandwidth (RBW/VBW)
This command is only available if a HP language is selected using SYSTem:LANGuage
on page 664.
Parameters:
<CouplingType> HP | FSP
*RST: FSP
Example:
SYSTem:HPC HP
Manual operation: See "Coupling" on page 404
SYSTem:IFGain:MODE <Mode>
Configures the internal IF gain settings in HP emulation mode due to the application
needs. This setting is only taken into account for resolution bandwidth < 300 kHz and is
only available if a HP language is selected using SYSTem:LANGuage on page 664.
Parameters:
<Mode> NORMal | PULSe
NORMal
Optimized for high dynamic range, overload limit is close to ref-
erence level.
PULSe
Optimized for pulsed signals, overload limit up to 10 dB above
reference level.
*RST: NORM
Example:
SYST:IFG:MODE PULS
Manual operation: See "IF Gain" on page 404
SYSTem:IDENtify:FACTory
This command resets the query to *IDN? to its default value.
Manual operation:
See "Reset to Factory String" on page 401
SYSTem:IDENtify[:STRing] <String>
This command defines the response to *IDN?.
General Instrument Setup