Rohde & Schwarz ESW Series - Frequency Configuration

Remote Commands in the Receiver Application
R&S
®
ESW
503User Manual 1177.6298.02 ─ 08
Suffix:
<tp>
.
Selects the trigger port to which the output is sent.
2 = trigger port 2 (front)
3 = trigger port 3 (rear)
Usage: Event
Manual operation: See "Send Trigger" on page 169
OUTPut:TRIGger<tp>:PULSe:LENGth <Length>
This command defines the length of the pulse generated at the trigger output.
Suffix:
<tp>
.
Selects the trigger port to which the output is sent.
2 = trigger port 2 (front)
3 = trigger port 3 (rear)
Parameters:
<Length> Pulse length in seconds.
Default unit: S
Example:
OUTP:TRIG2:PULS:LENG 0.02
Manual operation: See "Pulse Length" on page 169
15.6.3 Frequency Configuration
CALCulate<n>:MARKer<m>:FUNCtion:STRack[:STATe]....................................................503
CALCulate<n>:MARKer<m>:FUNCtion:STRack:BANDwidth.............................................. 504
CALCulate<n>:MARKer<m>:FUNCtion:STRack:THReshold...............................................504
CALCulate<n>:MARKer<m>:FUNCtion:STRack:TRACe.................................................... 504
DISPlay[:WINDow<n>]:TRACe<t>:X:SPACing.................................................................. 505
[SENSe:]FREQuency:CENTer......................................................................................... 505
[SENSe:]FREQuency:CENTer:STEP................................................................................506
[SENSe:]FREQuency:SCOupled..................................................................................... 506
[SENSe:]FREQuency:SPAN............................................................................................506
CALCulate<n>:MARKer<m>:FUNCtion:STRack[:STATe] <State>
This command turns signal tracking on and off.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Configuration