Common Analysis and Display Functions
R&S
®
ESW
190User Manual 1177.6298.02 ─ 08
11 Common Analysis and Display Functions
General methods and basic settings to display and analyze measurements, regardless
of the operating mode, are described here. If you are performing a specific measure-
ment task, using an application other than the Receiver application, be sure to check
the specific application or mode description for settings and functions that may deviate
from these common settings.
The analysis settings and functions are available via the "Analysis" dialog box, which is
displayed when you select the "Analysis" button in the "Overview". Additional measure-
ment-specific analysis functions may be available in separate tabs in the "Analysis"
dialog box.
● Result Display Configuration.................................................................................190
● Zoomed Displays.................................................................................................. 195
● Trace Configuration...............................................................................................197
● Marker Usage........................................................................................................226
● Display and Limit Lines......................................................................................... 239
11.1 Result Display Configuration
Measurement results can be evaluated in many different ways, for example graphically,
as tables, statistical evaluations. Thus, the result display is highly configurable to suit
your specific requirements and optimize analysis. Here you can find out how to work
and lay out the result display.
General display settings that are usually configured during initial instrument setup,
independently of the current measurement, for example which items or colors are dis-
played on the screen, are described in Chapter 13.2, "Display Settings", on page 305.
● Basic Evaluation Methods.....................................................................................190
● Laying out the Result Display with the SmartGrid.................................................191
11.1.1 Basic Evaluation Methods
Measurement results can be displayed and evaluated using various different methods,
also at the same time. You can control the type and number of results displays and
evaluation methods with the SmartGrid functionality.
For more information about the features available through the SmartGrid, refer to the
following topics.
●
Bargraph
– Chapter 9.2, "Bargraph Configuration", on page 97
●
Scan
– "Scan" on page 107
Result Display Configuration
To Next Page
Loading...
