Rohde & Schwarz ESW Series - Measurement Sequences

Remote Commands in the Receiver Application
R&S
®
ESW
443User Manual 1177.6298.02 ─ 08
Suffix:
<mt>
.
INITiate1 initiates a bargraph measurement.
INITiate2 initiates a scan.
Example: //Start a single scan (with a scan count = 20), and wait until the
measurement is done
INIT2:CONT OFF
SWE:COUN 20
INIT2;*WAI
Usage: Event
Manual operation: See "Performing continuous measurements" on page 95
See "Performing single measurements" on page 96
15.5.2 Measurement Sequences
CONFigure:RECeiver:MEASurement[:DEFault].................................................................443
INITiate:SEQuencer:ABORt............................................................................................ 443
INITiate:SEQuencer:IMMediate....................................................................................... 444
INITiate:SEQuencer:MODE.............................................................................................444
SYSTem:SEQuencer......................................................................................................444
CONFigure:RECeiver:MEASurement[:DEFault] <Measurement>
This command selects the measurement performed in a receiver channel during mea-
surement sequences.
More information
Parameters:
<Measurement> BARGraph
Performs a bargraph measurement.
NONE
Performs no measurement.
SCAN
Performs a scan.
*RST: SCAN
Example: //Perform a bargraph measurement in a measurement sequence
CONF:REC:MEAS BARG
INITiate:SEQuencer:ABORt
This command stops the currently active sequence of measurements.
You can start a new sequence any time using INITiate:SEQuencer:IMMediate
on page 444.
Usage:
Event
Manual operation: See "Sequencer State" on page 93
Measurements and Result Displays