Rohde & Schwarz ESW Series - Bandwidth and Filter Configuration; Bandwidth and Filter Settings; Impact of Bandwidth and Filter Settings

Common Measurement Settings
R&S
®
ESW
182User Manual 1177.6298.02 ─ 08
10.9 Bandwidth and Filter Configuration
The basic bandwidth, filter and sweep settings that apply to most measurements are
described here. These parameters define how the data is measured and which filters
are used.
● Impact of Bandwidth and Filter Settings................................................................182
● Bandwidth and Filter Settings............................................................................... 182
10.9.1 Impact of Bandwidth and Filter Settings
For more background information about bandwidths and filters refer to the following
topics:
●
Chapter 9.3.1.1, "Selecting the Measurement Bandwidth", on page 102
10.9.2 Bandwidth and Filter Settings
Access: "Overview" > "Bandwidth"
Functions in the "Bandwidth" dialog box described elsewhere:
●
"IF Analysis" on page 181
●
"Measurement Bandwidth" on page 101
●
"Filter Type" on page 101
CISPR RBW Uncoupled..............................................................................................182
CISPR RBW Uncoupled
Cancels the coupling of the IF bandwidth to the frequency range with the activated
quasipeak detector, CISPR average or RMS average detector.
See also Chapter 11.3.1.1, "Working with Trace Detectors", on page 198.
Remote command:
[SENSe:]BANDwidth[:RESolution]:AUTO on page 512
Bandwidth and Filter Configuration