Rohde & Schwarz ESW Series - Measurement Channel Synchronization

Remote Commands in the Receiver Application
R&S
®
ESW
648User Manual 1177.6298.02 ─ 08
Suffix Description
CMAP39 *) Table Value – Background
CMAP40 Trace 5
CMAP41 Trace 6
*) these settings can only be defined via the theme (DISPlay:THEMe:SELect on page 646) and are thus
ignored in the SCPI command
15.9.6 Measurement Channel Synchronization
● General Coupling Manager...................................................................................648
● Custom Coupling Manager................................................................................... 653
15.9.6.1 General Coupling Manager
Commands to configure parameter coupling described elsewhere.
●
OUTPut<ou>:LINK on page 499
INSTrument:COUPle:ACDC............................................................................................ 648
INSTrument:COUPle:ATTen............................................................................................ 649
INSTrument:COUPle:BWIDth.......................................................................................... 649
INSTrument:COUPle:BANDwidth.....................................................................................649
INSTrument:COUPle:CENTer..........................................................................................649
INSTrument:COUPle:DEMod.......................................................................................... 650
INSTrument:COUPle:GAIN............................................................................................. 650
INSTrument:COUPle:LLINes...........................................................................................650
INSTrument:COUPle:LIMit.............................................................................................. 650
INSTrument:COUPle:MARKer.........................................................................................651
INSTrument:COUPle:PRESel..........................................................................................651
INSTrument:COUPle:PROT............................................................................................ 651
INSTrument:COUPle:SPAN.............................................................................................652
INSTrument:COUPle:VBW..............................................................................................652
INSTrument:COUPle:ACDC <State>
This command turns synchronization of the AC / DC Coupling state between measure-
ment channels on and off.
Parameters:
<State> ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: ALL
Example:
INST:COUP:ACDC ALL
Synchronizes the "AC/DC Coupling" parameter.
General Instrument Setup