Rohde & Schwarz ESW Series - Page 651

Remote Commands in the Receiver Application
R&S
®
ESW
651User Manual 1177.6298.02 ─ 08
NONE | 0
Turns off synchronization.
*RST: ALL
Example:
INST:COUP:LIM ALL
Synchronizes the limit lines.
Manual operation: See "Synchronizing parameters across all measurement chan-
nels" on page 348
INSTrument:COUPle:MARKer <State>
This command turns synchronization of the receiver frequency in the Receiver applica-
tion and the Marker 1 frequency in the Spectrum application on and off.
Parameters:
<State> ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: NONE
Example:
INST:COUP:MARK ALL
Synchronizes the receiver frequency and the marker frequency.
Manual operation: See "Synchronizing parameters across all measurement chan-
nels" on page 348
INSTrument:COUPle:PRESel <State>
This command turns synchronization of the preselector configuration between mea-
surement channels on and off.
Parameters:
<State> ALL | 1
Turns on synchronization.
NONE | 0
Turns off synchronization.
*RST: ALL
Example:
INST:COUP:PRES ALL
Synchronizes the preselector configuration.
Manual operation: See "Synchronizing parameters across all measurement chan-
nels" on page 348
INSTrument:COUPle:PROT <State>
This command turns synchronization of the input protection between measurement
channels on and off.
General Instrument Setup