Rohde & Schwarz ESW Series - Gate Length

Common Measurement Settings
R&S
®
ESW
189User Manual 1177.6298.02 ─ 08
Remote command:
[SENSe:]SWEep:EGATe:HOLDoff on page 513
Gate Length
Defines how long the gate is open when it is triggered.
The gate length can only be set in the edge-triggered gate mode. In the level-triggered
mode the gate length depends on the level of the gate signal.
In the Spectrum application, the gate length in relation to the measurement is indicated
by a line labeled "GL".
For more information see Chapter 10.10.1.2, "Gated Measurements", on page 183
Remote command:
[SENSe:]SWEep:EGATe:LENGth on page 513
Trigger Configuration