Rohde & Schwarz ESW Series - Page 653

Remote Commands in the Receiver Application
R&S
®
ESW
653User Manual 1177.6298.02 ─ 08
15.9.6.2 Custom Coupling Manager
INSTrument:COUPle:USER<j>........................................................................................653
INSTrument:COUPle:USER<j>:CHANnel:LIST?................................................................653
INSTrument:COUPle:USER<j>:ELEMent:LIST?................................................................654
INSTrument:COUPle:USER<j>:INFO?............................................................................. 655
INSTrument:COUPle:USER<j>:NEW?............................................................................. 655
INSTrument:COUPle:USER<j>:NUMBers:LIST?............................................................... 657
INSTrument:COUPle:USER<j>:RELation..........................................................................658
INSTrument:COUPle:USER<j>:REMove.......................................................................... 658
INSTrument:COUPle:USER<j>:STATe..............................................................................659
INSTrument:COUPle:USER<j>:WINDow:LIST?.................................................................659
INSTrument:COUPle:USER<j> <see below>
This command edits an existing custom synchronization mechanism.
For a list of parameters, including return values, see INSTrument:COUPle:
USER<j>:NEW?. Note, however, that for INSTrument:COUPling:USER<j>, the last
two parameters (<Direction> and <State>) are not optional.
Note: Make sure to state the right index number via the suffix at USER.
Suffix:
<j>
.
Selects the index of a custom synchronization mechanism.
You can query the index with INSTrument:COUPle:USER<j>:
NUMBers:LIST?.
Example:
INST:COUP:USER3 'Receiver','All
Windows','Attenuation','Spectrum 2','All
Windows','Attenuation',BID,ON
Synchronizes the attenuation between the channels named
'Receiver' and 'Spectrum 2' in both directions and turns on the
coupling.
Manual operation: See "Selecting the channels to synchronize" on page 351
See "Selecting the measurement windows to synchronize"
on page 352
See "Selecting the parameter to synchronize" on page 352
See "Applying the coupling mechanism" on page 353
INSTrument:COUPle:USER<j>:CHANnel:LIST?
This command queries the names of the measurement channels that can be synchron-
ized.
Suffix:
<j>
.
irrelevant
Return values:
<Synchronizable
Channel>
All channels that can be synchronized (as a comma-separated
list of strings).
General Instrument Setup