Rohde & Schwarz ESW Series - Page 657

Remote Commands in the Receiver Application
R&S
®
ESW
657User Manual 1177.6298.02 ─ 08
BIDir
Changes of a parameter get applied both ways (from channel 1
to channel 2 and vice versa).
LTOR
Changes of a parameter get applied from channel 1 to channel
2, but not the other way around.
RTOL
Changes of a parameter get applied from channel 2 to channel
1, but not the other way around.
<State> ON | OFF
Optional SCPI parameter.
Return values:
<Index> Index number of the new custom coupling.
Note that the returned index numbers do not necessarily have to
be the same as those shown in the user interface.
Example:
INST:COUP:USER:NEW? 'Receiver','All
Windows','Attenuation','Spectrum','All
Windows','Attenuation',BID,ON
would return, e.g.:
3
Synchronizes the attenuation between the channels named
'Receiver' and 'Spectrum' in both directions and turns on the
coupling. Also returns the index number of the custom coupling.
Example:
INST:COUP:USER:NEW? 'All Receiver','All
Windows','Attenuation','','','',BID,ON
would return, e.g.:
3
Synchronizes the attenuation between all Receiver channels in
both directions and turns on the coupling. Also returns the index
number of the custom coupling.
Usage: Query only
Manual operation: See "Selecting the channels to synchronize" on page 351
See "Selecting the measurement windows to synchronize"
on page 352
See "Selecting the parameter to synchronize" on page 352
See "Applying the coupling mechanism" on page 353
INSTrument:COUPle:USER<j>:NUMBers:LIST?
This command queries the index number of custom synchronization mechanisms.
The index numbers define the range for suffix <j> available for the following com-
mands:
●
INSTrument:COUPle:USER<j>
●
INSTrument:COUPle:USER<j>:STATe
General Instrument Setup