Rohde & Schwarz ESW Series - Page 655

Remote Commands in the Receiver Application
R&S
®
ESW
655User Manual 1177.6298.02 ─ 08
Example: Case 1
INST:COUP:USER:ELEM:LIST?
would return a list of all parameters that you can synchronize:
'AC DC Coupling', 'Attenuation', 'Center
Frequency', 'Display Lines', 'Frequency Marker
1',...
Case 2
INST:COUP:USER:ELEM:LIST? 'Receiver'
would return all parameters that can be coupled in the 'Receiver'
channel:
'AC DC Coupling','Attenuation','Center
Frequency','Display Lines',...
Case 3
INST:COUP:USER:ELEM:LIST? 'Spectrum',
'Attenuation'
would return all parameters that can be coupled to 'Attenuation'
in the 'Spectrum' channel:
'Attenuation'
(Because the attenuation is the only parameter that can be cou-
pled to the attenuation.)
Usage:
Query only
Manual operation: See "Selecting the parameter to synchronize" on page 352
INSTrument:COUPle:USER<j>:INFO?
This command queries additional information about a custom coupling mechanism.
Suffix:
<j>
.
Selects the index of a custom synchronization mechanism.
You can query the index with INSTrument:COUPle:USER<j>:
NUMBers:LIST?.
Parameters:
<Information> String containing the message as displayed in the coupling man-
ager.
If the coupling message contains no message, an empty string
is returned.
Example:
INST:COUP:USER2:INFO?
Queries possible information about the user coupling with index
2, and would return, e.g.:
'Only one limit line allowed'
Usage: Query only
INSTrument:COUPle:USER<j>:NEW? <see below>
This command creates a new custom synchronization mechanism.
General Instrument Setup