Rohde & Schwarz ESW Series - Page 501

Remote Commands in the Receiver Application
R&S
®
ESW
501User Manual 1177.6298.02 ─ 08
15.6.2.2 Additional Output
OUTPut<ou>:PROBe<pb>[:POWer].................................................................................501
OUTPut<up>:TRIGger<tp>:DIRection.............................................................................. 501
OUTPut<up>:TRIGger<tp>:LEVel.................................................................................... 501
OUTPut<up>:TRIGger<tp>:OTYPe..................................................................................502
OUTPut:TRIGger<tp>:PULSe:IMMediate..........................................................................502
OUTPut:TRIGger<tp>:PULSe:LENGth............................................................................. 503
OUTPut<ou>:PROBe<pb>[:POWer] <State>
This command selects the probe connector that is supplied with power.
Suffix:
<ou>
.
irrelevant
<pb> Selects the probe power connector.
Parameters:
<State> ON | OFF | 1 | 0
Example: //Supply 5-pin probe connector with power
OUTP:PROB2 ON
Manual operation: See "Probe Power Supply" on page 167
OUTPut<up>:TRIGger<tp>:DIRection <Direction>
This command selects the trigger direction for trigger ports that serve as an input as
well as an output.
Suffix:
<up>
.
irrelevant
<tp> Selects the used trigger port.
2 = trigger port 2 (front)
3 = trigger port 3 (rear panel)
Parameters:
<Direction> INPut | OUTPut
INPut
Port works as an input.
OUTPut
Port works as an output.
*RST: INPut
Manual operation: See "Trigger 2/3" on page 168
OUTPut<up>:TRIGger<tp>:LEVel <Level>
This command defines the level of the (TTL compatible) signal generated at the trigger
output.
Configuration