Rohde & Schwarz ESW Series - Page 496

Remote Commands in the Receiver Application
R&S
®
ESW
496User Manual 1177.6298.02 ─ 08
[SENSe:]DEMod:SQUelch[:STATe].................................................................................. 499
SYSTem:SPEaker:MAXVolume....................................................................................... 500
SYSTem:SPEaker:MUTE................................................................................................500
SYSTem:SPEaker:VOLume............................................................................................ 500
OUTPut<ou>:IF:AUDio <State>
This command turns additional signal output on the headphone jack on and off.
Available for output 1 and output 2.
Suffix:
<ou>
.
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
Example: //Turn on audio output
OUTP:IF:AUD ON
Manual operation: See "Phones" on page 166
OUTPut<ou>:IF:COUPling <Coupling>
This command selects the output coupling type.
Available for the following output types:
●
Video
●
FM
Suffix:
<ou>
.
Output
Parameters:
<Coupling> AC
AC coupling: rejects the DC component of the signal.
DC
DC coupling: transfers the complete signal.
Example: //Select AC coupling for output 2
OUTP2:IF:COUP AC
Manual operation: See "Coupling" on page 165
OUTPut<ou>:IF:IFFRequency <Frequency>
This command defines the frequency of the IF signal that is output.
Available for output of the IF signal.
Suffix:
<ou>
.
Output
Parameters:
<Frequency> Default unit: Hz
Configuration