Rohde & Schwarz ESW Series - Page 497

Remote Commands in the Receiver Application
R&S
®
ESW
497User Manual 1177.6298.02 ─ 08
Example: //Output IF signal with a frequency of 100 MHz
OUTP:IF IF
OUTP:IF:IFFR 100MHZ
Manual operation: See "IF Output Frequency" on page 165
OUTPut<ou>:IF:LPASs:FREQuency:MANual <Frequency>
This command defines the cutoff frequency of the low pass filter available for signal
output.
Available for the following output types:
●
Video
●
AM
●
FM
●
PM
This command is available after you have turned on the low pass filter with
OUTPut<ou>:IF:LPASs[:STATe].
Suffix:
<ou>
.
Output
Parameters:
<Frequency> Default unit: Hz
Example: //Turn on low pass filter with a cutoff frequency of 100 kHz
OUTP:IF:LPAS ON
OUTP:IF:LPAS:FREQ:MAN 100KHZ
Manual operation: See "Low Pass" on page 165
OUTPut<ou>:IF:LPASs[:STATe] <State>
This command turns a low pass filter to control the output on and off.
Available for the following output types:
●
Video
●
AM
●
FM
●
PM
Suffix:
<ou>
.
Output
Parameters:
<State> ON | OFF | 1 | 0
Example: //Turn on low pass filter with a cutoff frequency of 100 kHz
OUTP:IF:LPAS ON
OUTP:IF:LPAS:FREQ:MAN 100KHZ
Manual operation: See "Low Pass" on page 165
Configuration