Rohde & Schwarz ESW Series - Page 552

Remote Commands in the Receiver Application
R&S
®
ESW
552User Manual 1177.6298.02 ─ 08
CALCulate<n>:MARKer<m>:SPECtrogram:Y:MAXimum:ABOVe........................................ 553
CALCulate<n>:MARKer<m>:SGRam:Y:MAXimum:BELow.................................................554
CALCulate<n>:MARKer<m>:SPECtrogram:Y:MAXimum:BELow.........................................554
CALCulate<n>:MARKer<m>:SGRam:Y:MAXimum:NEXT...................................................554
CALCulate<n>:MARKer<m>:SPECtrogram:Y:MAXimum:NEXT.......................................... 554
CALCulate<n>:MARKer<m>:SGRam:Y:MAXimum[:PEAK].................................................554
CALCulate<n>:MARKer<m>:SPECtrogram:Y:MAXimum[:PEAK]........................................ 554
CALCulate<n>:MARKer<m>:SGRam:Y:MINimum:ABOVe..................................................554
CALCulate<n>:MARKer<m>:SPECtrogram:Y:MINimum:ABOVe......................................... 554
CALCulate<n>:MARKer<m>:SGRam:Y:MINimum:BELow.................................................. 555
CALCulate<n>:MARKer<m>:SPECtrogram:Y:MINimum:BELow..........................................555
CALCulate<n>:MARKer<m>:SGRam:Y:MINimum:NEXT....................................................555
CALCulate<n>:MARKer<m>:SPECtrogram:Y:MINimum:NEXT........................................... 555
CALCulate<n>:MARKer<m>:SGRam:Y:MINimum[:PEAK].................................................. 555
CALCulate<n>:MARKer<m>:SPECtrogram:Y:MINimum[:PEAK]..........................................555
CALCulate<n>:MARKer<m>:SGRam:FRAMe <Frame> | <Time>
CALCulate<n>:MARKer<m>:SPECtrogram:FRAMe <Frame> | <Time>
This command positions a marker on a particular frame.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Frame> Selects a frame directly by the frame number. Valid if the time
stamp is off.
The range depends on the history depth.
Default unit: S
<Time> Selects a frame via its time stamp. Valid if the time stamp is on.
The number is the (negative) distance to frame 0 in seconds.
The range depends on the history depth.
Example:
CALC:MARK:SGR:FRAM -20
Sets the marker on the 20th frame before the present.
CALC:MARK2:SGR:FRAM -2s
Sets second marker on the frame 2 seconds ago.
Manual operation: See "Frame (Spectrogram only)" on page 232
Analysis