Rohde & Schwarz ESW Series - Page 540

Remote Commands in the Receiver Application
R&S
®
ESW
540User Manual 1177.6298.02 ─ 08
CALCulate<n>:MARKer<m>[:STATe] <State>
This command turns markers on and off. If the corresponding marker number is cur-
rently active as a delta marker, it is turned into a normal marker.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Example:
CALC:MARK3 ON
Switches on marker 3.
Manual operation: See "Marker State" on page 231
See "Marker Type" on page 232
See "Select Marker" on page 232
CALCulate<n>:MARKer<m>:TRACe <Trace>
This command selects the trace the marker is positioned on.
Note that the corresponding trace must have a trace mode other than "Blank".
If necessary, the command activates the marker first.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Trace>
Example: //Assign marker to trace 1
CALC:MARK3:TRAC 2
Manual operation: See "Assigning the Marker to a Trace" on page 232
CALCulate<n>:MARKer<m>:X <Position>
This command moves a marker to a specific coordinate on the x-axis.
If necessary, the command activates the marker.
If the marker has been used as a delta marker, the command turns it into a normal
marker.
Suffix:
<n>
.
Window
Analysis