Rohde & Schwarz ESW Series - Page 541

Remote Commands in the Receiver Application
R&S
®
ESW
541User Manual 1177.6298.02 ─ 08
<m> Marker
Parameters:
<Position> Numeric value that defines the marker position on the x-axis.
The unit depends on the result display.
Range: The range depends on the current x-axis range.
Default unit: Hz
Example:
CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
Manual operation: See "Marker Position X-value" on page 231
15.7.4.2
General Marker Configuration
CALCulate<n>:MARKer<m>:SCOupled:LSCan.................................................................541
CALCulate<n>:MARKer<m>:SCOupled[:STATe]................................................................541
DISPlay[:WINDow<n>]:MINFo[:STATe].............................................................................542
DISPlay[:WINDow<n>]:MTABle....................................................................................... 542
CALCulate<n>:MARKer<m>:SCOupled:LSCan <State>
This command selects the measurement configuration to be applied when you couple
receiver settings to scan range settings.
Prerequisites for this command
●
Couple receiver settings to scan range settings (CALCulate<n>:MARKer<m>:
COUPled[:STATe]).
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<State> ON | 1
Applies the configuration used during the last scan.
OFF | 0
Applies the current configuration.
This has an effect only if you have changed anything since the
last scan.
*RST: OFF
Example: //Couple receiver settings to the scan range settings
CALC:MARK:COUP ON
CALC:MARK:SCO:LSC ON
Manual operation: See "Settings Coupled" on page 234
CALCulate<n>:MARKer<m>:SCOupled[:STATe] <State>
This command couples or decouples the marker frequency to the scan range settings.
Analysis