Rohde & Schwarz ESW Series - Page 399

Network and Remote Operation
R&S
®
ESW
399User Manual 1177.6298.02 ─ 08
Risk of network problems
All parameters can be edited here; however, beware that changing the computer name
has major effects in a network.
For details, see Chapter 14.5, "How to Set Up a Network and Remote Control",
on page 409.
Network settings in secure user mode
Be sure to store all network settings before SecureUser Mode is enabled; see Chap-
ter 4.7, "Protecting Data Using the Secure User Mode", on page 40.
If the currently stored network settings are not suitable, you must correct them each
time you switch on the R&S ESW in secure user mode, as the settings are not stored
permanently in this case.
Computer Name..........................................................................................................399
IP Address...................................................................................................................400
Subnet Mask............................................................................................................... 400
DHCP..........................................................................................................................400
Network Configuration.................................................................................................400
Computer Name
Each instrument is delivered with an assigned computer name, but this name can be
changed. The naming conventions of Windows apply. If too many characters and/or
numbers are entered, an error message is displayed in the status line.
The default instrument name is a non-case-sensitive string with the following syntax:
<Type><variant>-<serial_number>
For example ESW26-123456
The serial number can be found on the rear panel of the instrument. It is the third part
of the device ID printed on the bar code sticker:
Network and Remote Control Settings