Common Analysis and Display Functions
R&S
®
ESW
248User Manual 1177.6298.02 ─ 08
This setting does not have any effect on limit lines that are defined by absolute values
for the x-axis.
Remote command:
CALCulate<n>:LIMit<li>:CONTrol:OFFSet on page 564
Y-Offset
Shifts a limit line that has relative values for the y-axis (levels or linear units such as
volt) vertically.
This setting does not have any effect on limit lines that are defined by absolute values
for the y-axis.
Remote command:
CALCulate<n>:LIMit<li>:LOWer:OFFSet on page 565
CALCulate<n>:LIMit<li>:UPPer:OFFSet on page 567
Limit Check
Turns limit checks for pre-measurement on and off.
Create New Line
Creates a new limit line.
Edit Line
Edit an existing limit line configuration.
Copy Line
Copy the selected limit line configuration to create a new line.
Remote command:
CALCulate<n>:LIMit<li>:COPY on page 564
Delete Line
Delete the selected limit line configuration.
Remote command:
CALCulate<n>:LIMit<li>:DELete on page 564
Disable All Lines
Disable all limit lines in one step.
Remote command:
CALCulate<n>:LIMit<li>:STATe on page 565
Limit Line Details
Access: "Overview" > "Analysis" > "Lines" > "Limit Lines" > "New" / "Edit" / "Copy To"
Display and Limit Lines
To Next Page
Loading...
