Rohde & Schwarz ESW Series - Page 313

General Instrument Setup
R&S
®
ESW
313User Manual 1177.6298.02 ─ 08
●
Grid
●
Individual traces
●
Display lines
●
Limit lines and check results
●
Markers and marker information
Remote command:
Each object is assigned to a specific suffix of the CMAP commands, see Chap-
ter 15.9.5.3, "CMAP Suffix Assignment", on page 646.
Predefined Colors ← Modifying User-Defined Color Assignments
Displays the available colors from the predefined color set that can be used for the
selected object.
Remote command:
HCOPy:CMAP<it>:PDEFined on page 595
Preview ← Modifying User-Defined Color Assignments
Indicates the currently selected color that will be used for the selected object.
Defining User-specific Colors
In addition to the colors in the predefined color set you can configure a user-specific
color to be used for the selected object.
When you select "Userdefined Colors...", the set of predefined colors is replaced by a
color palette and color configuration settings.
The color palette allows you to select the color directly. The color settings allow you to
define values for tint, saturation and brightness.
Remote command:
HCOPy:CMAP<it>:HSL on page 595
Restoring the User Settings to Default Colors
In addition to the predefined color settings, a user-defined setting can be configured.
By default, the same settings as defined in "Default Colors 1" are used. They can then
be modified according to user-specific requirements (see "Modifying User-Defined
Color Assignments" on page 312).
The "Set to Default" function restores the original default settings for the user-defined
color set. You can select which of the three default settings are restored.
Display Settings