EasyManua.ls Logo

Rohde & Schwarz ESW Series - Page 425

Rohde & Schwarz ESW Series
759 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Network and Remote Operation
R&S
®
ESW
425User Manual 1177.6298.02 ─ 08
The options for configuring the R&S ESW screen display are displayed.
11. Under "Remote desktop size", you can set the size of the R&S ESW window on the
desktop of the controller.
12. Under "Colors", do not change the settings.
13. Set the "Display the connection bar when I use the full screen" option:
If activated, a bar showing the network address of the R&S ESW will appear at
the top edge of the screen. You can use this bar to reduce, minimize or close
the window.
If deactivated, the only way you can return to the controller desktop from the
R&S ESW screen in full screen mode is to select "Disconnect" from the "Start"
menu.
14.5.7.3 How to Start and Close the Remote Desktop
To set up a connection to the R&S ESW
1. In the "Remote Desktop Connection" dialog box (see Chapter 14.5.7.2, "How to
Configure the Controller", on page 423), open the "General" tab.
2. In the "Computer" field, enter the IP address of the R&S ESW.
In the "User name" field, enter instrument to log in as an administrator, or Normal
User to log in as a standard user.
In the "Password" field, enter 894129.
3. To save the connection configuration for later use:
a) Select the "Save As" button.
The "Save As" dialog box is displayed.
b) Enter the name for the connection information (*.RDP).
4. To load an existing connection configuration:
a) Select the "Open" button.
The "Open" dialog box is displayed.
b) Select the *.RDP file.
5. Select the "Connect" button.
The connection is set up.
6. If the "Disk drives" option is activated on the "Local Resources" tab, a warning is
displayed indicating that the drives are enabled for access from the R&S ESW.
Select "OK" to confirm the warning.
7. After a few moments, the R&S ESW screen is displayed.
If a dark screen appears or a dark square appears in the upper left-hand corner of
the screen, you must restart the R&S ESW in order to see the modified screen res-
olution.
How to Set Up a Network and Remote Control

Table of Contents

Related product manuals