Rohde & Schwarz ESW Series - Page 456

Remote Commands in the Receiver Application
R&S
®
ESW
456User Manual 1177.6298.02 ─ 08
[SENSe:]FREQuency:STOP <Frequency>
This command defines the stop frequency of a scan.
In the Spectrum application, the command defines the stop frequency of a measure-
ment.
Parameters:
<Frequency> <numeric value>
Range: Refer to the datasheet
*RST: depends on application
Default unit: Hz
Example: //Define stop frequency
FREQ:STOP 100MHz
Manual operation: See "Defining a frequency range for the scan" on page 117
See "Start / Stop Frequency" on page 179
[SENSe:]SCAN<sr>:BANDwidth:RESolution <Bandwidth>
This command defines the resolution bandwidth applied in the selected scan range.
Suffix:
<sr>
.
Selects the scan range.
Parameters:
<Bandwidth> <numeric value>
If you enter a resolution bandwidth that is not supported, the
R&S ESW uses the next available bandwidth instead.
Range: Refer to datasheet
Default unit: Hz
Example: //Define a measurement bandwidth for the 4th scan range
SCAN4:BAND:RES 1MHz
Manual operation: See "Measurement Bandwidth" on page 101
[SENSe:]SCAN<sr>:BARS <State>
This command turns the display of the bars indicating the size of a scan range on and
off.
Suffix:
<sr>
.
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
*RST: ON
Example: //Turn on range bars
SCAN:BARS ON
Manual operation: See "Displaying range bars" on page 118
Measurements and Result Displays