Rohde & Schwarz ESW Series - Page 642

Remote Commands in the Receiver Application
R&S
®
ESW
642User Manual 1177.6298.02 ─ 08
Note: This setting is maintained even after using the [PRESET] function.
Parameters:
<State> ON | OFF
*RST: ON
Example:
DISP:ITER ON
Displays the icon in the toolbar.
Manual operation: See "Disconnect RF" on page 310
DISPlay:SBAR[:STATe]
<State>
This command turns the status bar on and off.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:SBAR:OFF
Manual operation: See "Status Bar" on page 307
DISPlay:SKEYs[:STATe] <State>
This command turns the softkey bar on and off.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:SKEY:OFF
Manual operation: See "Softkey Bar" on page 307
DISPlay:TBAR[:STATe] <State>
This command turns the toolbar on or off.
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
DISP:TBAR ON
Manual operation: See "Toolbar" on page 307
DISPlay:TOUChscreen[:STATe] <State>
This command controls the touch screen functionality.
Parameters:
<State> ON | FRAMe | OFF
General Instrument Setup