Rohde & Schwarz SGS100A - Page 110

Signal Generator Settings
R&S
®
SGS100A
108User Manual 1173.9105.02 ─ 12
The "Overview" tab shows the list of detected sensors, and provides a separate tab
per sensor.
A sensor tab contains all parameters for configuring the sensor settings, like aver-
age or peak display, reference source, filter and level offset.
The remote commands required to define these settings are described in Chap-
ter 11.12, "SENSe, READ, INITiate and SLISt Subsystems", on page 223, includ-
ing the triggering of the measurement and the retrieval of measurement results.
Settings:
Sensor type and serial number .................................................................................. 109
Level (Peak) / Level (Average) ...................................................................................109
Sensor Mapping..........................................................................................................109
Sensor Settings...........................................................................................................109
└ State .............................................................................................................109
└ Zero ..............................................................................................................109
Level and Power-On Settings