Signal Generator Settings
R&S
®
SGS100A
113User Manual 1173.9105.02 ─ 12
Modulation signal sources
The R&S SGS provides the following signal sources for the signal modulation:
●
Internal: A high-performance pulse generator, that allows you to generate either
single or double pulse signals
●
Externally supplied signal: the instrument expects the pulse modulation signals
at the [TRIG] connector.
Pulse modulation signal waveforms
The high-performance pulse generator enables you to generate single or double pulse
signals.
Figure 7-3: Pulse generator - single pulse mode
1 = Pulse period
2 = Pulse width
3 = Pulse delay
Figure 7-4: Pulse generator - double pulse mode
1 = Pulse period
2 = Pulse width
3 = Double pulse width
4 = Double pulse delay
Pulse Modulation
To Next Page
Loading...
