Rohde & Schwarz SGS100A - Page 236

Remote Control Commands
R&S
®
SGS100A
234User Manual 1173.9105.02 ─ 12
Return values:
<SNumber> string
Example:
SENS1:SNUM?
Queries the serial number.
Usage: Query only
Manual operation: See " Sensor type and serial number " on page 109
:SENSe<ch>[:POWer]:SOURce <Source>
Determines the signal to be measured.
Note: When measuring the RF signal, the sensor considers the corresponding correc-
tion factor at that frequency, and uses the level setting of the instrument as reference
level.
Parameters:
<Source> A | USER | RF
*RST: A
Example: See Example "Performing a power measurement with a fixed fil-
ter" on page 225.
Manual operation: See " Source" on page 110
:SENSe<ch>[:POWer]:STATus[:DEVice]?
Queries if a sensor is connected to the instrument.
Return values:
<Status> 0 | 1 | OFF | ON
*RST: 0
Example:
SENS1:STAT?
Response: 1
A sensor is connected.
Usage: Query only
Manual operation: See " State " on page 109
:SENSe<ch>[:POWer]:SVERsion?
Queries the software version of the connected R&S NRP power sensor.
Return values:
<SVersion> string
Example:
SENS1:POW:SVER?
Queries the software version of the power sensor.
Usage: Query only
SENSe, READ, INITiate and SLISt Subsystems