System Overview
R&S
®
SGS100A
45User Manual 1173.9105.02 ─ 12
5. In the R&S SGMA-GUI main panel, the green indicator in front of the instrument's
name confirms that there is a connection between the instrument and the remote
PC and that the instrument is recognized by the software.
6. Select "SGMA-GUI main panel > R&S SGS > Extension".
The "Extension" dialog opens.
Tip: Instrument doesn't appear in the extension dialog. If the R&S SGU is not auto-
matically shown in this dialog press "Scan > Start" to find the instrument.
7. Select the R&S SGU from the list and set "Available Instruments > Select > On" to
enable it as an extension.
A green status indicator "Connected" indicates the successfully established remote
connection between the R&S SGS ant the R&S SGU.
The R&S SGMA-GUI indicates the extended frequency range of the R&S SGS and
the activated extension mode.
8. Select "Test Signal Connections > Test" to trigger a check of all required signal
connections.
Setups for Connecting an R&S SGS and an R&S SGU
To Next Page
Loading...
